Replacement Parts
In the event any one component begins to fail, here is a list of all the components in the system, and general repair instructions.
Primary Components
This will most likely be the most involved piece to replace, however should be the last. It is much more likely that a fuse will blow.
Any 12V 25A Power Supply should suffice. View the Power Sheet for any additional questions. Power supply takes in AC Live/Neutral/Earth and outputs DC +12v/gnd. Bring two wires from +12v on power supply into the positive terminals on the controller. Do the same for ground. Power supply is mounted using command strips.
In all seriousness, if you need to replace these you will need to once again contact the manufacturer. Because it is not a bulk order, (100m+), they will charge an additional fee. Very involved repair to move all clips over to a new strip. Use the previous setup as a reference. We bought them from Suntech LEDS.
Secondary Components
Screw Terminals
Anything like this should suffice. This technically is not necessary, however helps to clean up the system and make it more maintainable. It connects the fused outputs from the controller to the led strip plugs.
Male/Female Wire Connectors
These are the parts used to easily connect/disconnect the strip from the control board. They can be found an aliexpress here. In the event this link goes down, I believe they can be found by "XT60 2 pin wire connectors"